General shower room installation process

The first step: install the bottom basin of the shower room. The shower room manufacturer will first combine the parts of the bottom basin, confirm the levelness of the bottom basin, and ensure that there is no accumulation of water in the basin and the bottom of the basin. , and then connect the pelvic floor to the floor drain firmly. If the bottom basin is not used, the water retaining strip of the shower room is to be attached to the floor tiles when the tiles are to be installed. The reason for this is to have a good water resistance.

The second step: inspection and maintenance: After the shower room manufacturer is installed, it needs to conduct a water test to ensure that the water is accessible in all directions. Positioning and drilling: Confirm the drilling position of the aluminum material against the wall with a pencil and a spirit level, and punch with an impact drill.

Step 3: Install the aluminum material: Knock in the expansion screw at the drilled hole, and use the screw to lock the aluminum strip to the wall.

Step 4: Fix the glass: Clamp the glass to the hole in the bottom basin, and then fix it with screws.

Step 5: Install the pipe jacking: Find the corresponding azimuth hole above the fixed glass, install the fixing seat and connect the jacking pipe. Secure it to the top of the glass with an elbow sleeve.

Step 6: Install the rack: Select the orientation to install the sanitary ware.

Step 7: Install the movable door: Install the hardware of the movable door, and install the hinge in the reserved hole of the fixed door. After the shower room manufacturer is installed, it will adjust the axis position of the lotus leaf, and it will stop when the door is closed.

Step 8: Do a good job of waterproofing: install suction strips or water-retaining strips next to or below the glass as required. Use silicone to seal the joints between aluminum and wall, glass and bottom basin.

The ninth step: debugging and tightening: check whether each part is used comfortably and smoothly, and adjust it in time if any problem is found. After adjustment, tighten the corresponding screws to make the entire shower room more solid.

Step 10: Finishing work: snap the decorative aluminum strips into the wall-mounted aluminum material to ensure its appearance is neat and generous. Eventually the entire shower will be wiped clean with a rag.